《树脂开闭器》特性说明 / speciality

1.由斜度螺丝调整木板与树脂间之摩擦力，约转1/4可合闭模具约5万次。
2.模具装置取卸容易、简单，价格低。
3.此装置也可用在小水口板与打中板或二段顶出小水口或滑座之工件上。
4.模具重量100kg以下用12Φ-4个，500kg以下用16Φ-4个,1000kg以下用20Φ-4个。若超过1000kg以上,则增加为6个以上。
5.树脂埋入公模板约3公分，母模之孔以H7之绞刀加工至+0.1mm范围内内面加至□□□~□□□
6.母模面请加工成R状。如做C面之倒角，耐久性较差。
7.请勿在树脂上加油，因为加油会使摩擦力减低。
分：白 黄 橘三色 Division:white,yellow,orange three colors

Features

1.Use sloping screw to adjust mold  plate and  parting locks  ,then  turn  90 degrees  parting locks can be closed up to 50000times
 2.Easy to assemble and disassemble,and cost efficient.
 3.Can also be installed into small,medium size,and 2-sectional injecting metal pipes,or can be installed on sliding bases.
 4.Mold weight  100kg,using 4pcs 0f 12Φ.Mold weight 500kg,using 4pcs of  16Φ Mold  weight 1000kg, using 4pcs of  20Φ. Mold weight 1000kg,  using at least 6pcs.
 5.Insert parting locks into die mold about 3cm ,the using H7 reamer to processing mold hole within+0.1mm range.
 6.Process mold surface to the shape of letter“R”,if processing to the chamfering of letter“C”it will shorten it’s life cycle.
 7.Do not add any oil on paring locks.doing so will reduce the friction.